Before applying your Vinyl Lettering or Graphics thoroughly clean and dry the area first

Position the lettering in the desired place
and secure temporarily with a high tack
masking tape as shown opposite
"Vinyl Letters"

Apply masking tape along the top edge of
the lettering or graphics and the surface its
being applied to thus creating a hinge
"Vinyl Lettering"

When dealing with large letters or long
lengths of lettering cut in between each
individual letter first as shown opposite
"Self adhesive vinyl letters"

Lift up the vinyl on its hinge and completely
remove the backing paper as shown opposite and put this to one side for later
"Vinyl Stickers"

Slowly and carefully allow your vinyl to
come back down and make contact with
the surface its being applied to
Fitting your lettering or graphics

Using a squeegee with a firm pressure 
start at the top centre, work downwards
and outwards when applying the lettering
to the surface
"Vinyl Decals"

Start removing the application tape at one
corner and slowly draw it back on itself
at 180 degrees as shown opposite
Fitting your lettering or graphics

To ensure the vinyl is firmly attached cover it with the backing paper, the shinny side facing
the vinyl, and squeegee again.  Any air bubbles pop them with a pin and squeegee again.