Got a Question? Call 0191 4423962 / 07795 633 840

Application Guide

Fitting your Vinyl Lettering is a relatively straightforward process, all you need are a few basic tools.
A tape measure, a pair of scissors, a squeegee ( recommended ) high tack masking tape, and a little care.

Step 1. Image

Step 1.

Position the lettering in the desired place and secure temporarily with a high tack masking tape.

Step 2. Image

Step 2.

Apply masking tape along the top edge of the lettering or graphics and the surface its being applied to thus creating a hinge.

Step 3. Image

Step 3.

Lift up the vinyl on its hinge and completely remove the backing paper and put this to one side for later.
Slowly lower the lettering back down.

Step 4. Image

Step 4.

Using a squeegee with a firm pressure start at the top centre, work downwards and outwards when applying the lettering.

Step 5. Image

Step 5.

Start removing the application tape at one corner and slowly draw it back on itself at 180 degrees to the surface.

Step 6. Image

Step 6.

To ensure the vinyl is firmly attached cover it with the backing paper, the shinny side facing the vinyl, and squeegee again. Any air bubbles pop them with a pin and squeegee again.